Mode d'emploi Amana NTW4701BQ Lave-Linge - Notice page 4
Select the setting most suitable for your load. Ex small or
Small (depending on model) will add a low amount of water
for smaller loads and Large will add the most amount of
water for large or bulky loads. Items need to move freely.
Tightly packing can lead to poor cleaning performance, and
may increase wrinkling and tangling.
Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water safe for your fabric.
■ On some models and cycles, warm and hot water may
be cooler than your previous washer.
■ Even in a cold and cool water wash, some warm
water may be added to the washer to maintain
a minimum temperature.
FABRIC SOFTENER (on some models)
This option can be added to most cycles and must be set
to YES if using fabric softener during a cycle. It ensures that
fabric softener is added at the correct time in the rinse for
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
Knob does not advance during the progress of the cycle, see
cycle status lights for each stage of the process. See “Cycle
Guide” for detailed descriptions of cycles.
START/PAUSE/UNLOCK LID BUTTON
Press to start the selected cycle; press again to pause
the cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several
minutes to unlock the lid. Press and hold for 3 seconds
to cancel a cycle.
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle. At
each stage of the process, you may notice sounds or pauses
that are different from traditional washers.
When the START/Pause/Unlock Lid button is pressed,
the washer will ll to the selected water level. If the lid is
closed when the machine is done lling the lid will lock
and the machine will begin operation.
If the lid is open when the water stops entering the
machine, the cycle will not begin until the lid has been
closed and the START/Pause/Unlock Lid button is
pressed. If the cycle has not been started within
10 minutes of the water lling the washer, the washer
will pump out the water.
CONTROL PANEL & FEATURES
Not all features and options are available on all models.
Appearance may vary.